50rds. .22lr CMMG conversion for Stag AR15
150rds. Kriss Vector Carbine 9mm
50rds. CZ SP-01 9mm
50rds. HK VP9 9mm
30rds. CZ 40B .40SW
30rds. HK P30L .40SW
100rds.
Build #1 AR15
210rds.
Build #5 AR15
The .22lr conversion worked well. Even put some doubles downrange with the Build #5 lower's binary trigger. Way too easy to chew through rounds.
Enjoyed shooting the Vector. Sighted in an MRO on it. Fun gun.
Got my best pistol groups with the CZ and the RMR. Although the VP9 shot very well and I liked it quite a bit.
The 40B I didn't do well with. Bought the gun used and the guy put sights on it that I don't seem to like. Will swap them out at some point. I wasn't very accurate with the P30L either, but definitely better. Preferred both the 9's and especially look forward to messing around with the CZ again soon.
Put a new bolt carrier in Build 1 since it was experiencing a little bit of hang up, which was causing failures. No failures today. Ran great in both single-shot and binary modes.
First time shooting the Build #5 upper. Worked great with the federal rounds. The ATI rounds were kicking back at me. Realized later that it should be possible to adjust the gas so that might have helped. Mostly though I needed to put some rounds downrange because the manual says run the first few hundred rounds via magazine. Sooo, close enough. Sighted the Elcan in on it. Cool 3x scope.